Yamaha S80 EN - Manual (Page 21)

EQ Settings
Click on the text box and choose the equalizer type. Using the EQ/LH type as an example,
the left square mark controls the bass frequencies and the right square mark controls the
treble frequencies. Drag the square marks vertically to adjust gain, and horizontally to
adjust the frequency.
n
To set these values directly, select the “OSCILLATOR” tab of the “EL DETAIL” dialog.
PITCH EG Settings
The PITCH EG (Envelope Generator) determines the transition in pitch while the key is being
held down. There are five square marks, each controlling a different stage in the envelope.
The first square mark (furthest to the left) controls the “Hold Time/Level.” The second
controls the “Attack Time/Level.” The third controls the “Decay 1 Time/Level.” The fourth
controls the “Decay 2 Time/Sustain Level.” The last square mark (furthest to the right)
controls the “Release Time/Level.” Drag the square marks vertically to adjust levels, and
horizontally to adjust the transition times.
n
To set these values directly, select the “PITCH” tab of the “EL DETAIL” dialog.
FILTER EG Settings
The FILTER EG (Envelope Generator) determines the transition in timbre while the key is
being held down. There are five square marks, each controlling a different stage in the
envelope. The first square mark (furthest to the left) controls the “Hold Time/Level.” The
second controls the “Attack Time/Level.” The third controls the “Decay 1 Time/Level.” The
fourth controls the “Decay 2 Time/Sustain Level.” The last square mark (furthest to the right)
controls the “Release Time/Level.” Drag the square marks vertically to adjust levels, and
horizontally to adjust the transition times.
n
To set these values directly, select the “FILTER EG” tab of the “EL DETAIL” dialog.
AMPLITUDE EG Settings
The AMPLITUDE EG (Envelope Generator) determines the transition in amplitude over time.
There are five the square marks, each controlling a different stage in the envelope. The first
square mark (furthest to the left) controls the “Init Level.” The second controls the “EG
Attack Time.” The third controls the “EG Decay 1 Time/Level.” The fourth controls the
“Decay 2 Time/Sustain Level.” The last square mark (furthest to the right) controls the “EG
Release Time.” Drag the square marks vertically to adjust levels, and horizontally to adjust
the transition times.
n
To set these values directly, select the “AMP EG” tab of the “EL DETAIL” dialog.
21