Yamaha CVP-208 EN - Manual (Page 155)

155 CVP-210/208
Using Your Clavinova with Other Devices
1 Using the Headphones
(PHONES jacks).
To use headphones, connect them to one of the PHONES
jacks (standard 1/4" phone jacks) located on the under-
side of the keyboard. You can also determine whether or
not the internal stereo speaker system is shut off when a
pair of headphones is plugged into the PHONES jack
(page 152). Two people can enjoy listening to the Clavi-
nova together by connecting two pairs of headphones to
the two jacks.
2 Connecting the Microphone
or Guitar (MIC./LINE IN jack).
By connecting a microphone to the Clavinova, you can
enjoy singing along with your own performance or song
playback. (A dynamic microphone is recommended.) The
Clavinova outputs your vocals or guitar sounds through
the built-in speakers.
1 Connect your microphone to the MIC./LINE IN jack
(standard 1/4" phone jack).
2 Set the [MIC. LINE] switch (located next to the MIC./
LINE IN jack) to the MIC. position.
3 Use the [INPUT VOLUME]
knob (located next to the
MIC./LINE IN jack) to set the
microphone volume.
The volume should be set high
enough that the SIGNAL lamp
on the front panel lights steadily when you sing, but
not so high that the OVER lamp lights (page 131).
Before connecting the Clavinova to other electronic components,
turn off the power to all the components. Before turning the power
on or off to all components, set all volume levels to minimum (0).
Otherwise, electrical shock or damage to the components may
occur.
CAUTION
MIN MAX
INPUT MIC. MIC. LINE PHONES VOLUME LINE IN
1 2
Use an unidirectional microphone for best results.
MIC. LINE MIC. LINE
When connecting a microphone When connecting a guitar
You should set the [MIC. LINE] switch to the LINE position when
connecting an audio source with line-level output to the MIC./LINE
IN jack.
THRU OUT IN
MIDI
VIDEO OUT AUX IN AUX OUT
AUX PEDAL USB
L/L+R R L/L+R R R L
(LEVEL FIXED)
8 6
5 4 3
7
P.156 P.156 P.156
P.157 P.157 P.157