Yamaha CVP-208 EN - Manual (Page 17)

17 CVP-210/208
Connect the power cord
1 Insert the plugs at the ends of the cord, one into the
AC INLET on the Clavinova, and the other into a
standard AC outlet.
In some areas, a plug adapter may be provided to
match the pin configuration of the AC wall outlets in
your area.
(The shape of plug differs depending on locale.)
2 Press the [POWER] switch.
→
The main display appears in the LCD display. The
drive lamp below the lower right end of the
keyboard also lights.
When you’re ready to turn off the power, press the
[POWER] switch again.
→
Both the display and the drive lamp below the
right end of the keyboard will turn off.
Setting the volume
Use the [MASTER VOLUME] dial to adjust the volume to
an appropriate level.
CAUTION
Do not use the Clavinova at a high volume level for a long period of
time, or your hearing may be damaged.
Connect a pair of headphones to one of the [PHONES]
jacks.
Two [PHONES] jacks are provided.
Two sets of standard stereo headphones can be plugged
in. (If you are using only one pair of headphones, you
can plug them into either of these jacks.)
Using the Headphone Hanger
A headphone hanger is included in the CVP-210/208
package so that you can hang the headphones on the
Clavinova. Install the headphone hanger using included
two screws (4
× 10 mm) as shown in the figure.
CAUTION
Do not hang anything other than the headphones on the hanger.
Otherwise, the Clavinova or the hanger may be damaged.
Turning the Power On
and Off
The drive lamp lights.
POWER
ON OFF
BALANCE
CHANNEL ON OFF
PART
A
E
D
C
B
BACK
MIN MAX
MASTER VOLUME
FADE IN / OUT
Using headphones
MIN MAX
INPUT MIC. MIC. LINE PHONES VOLUME LINE IN