Yamaha YST-SW800 - Manual (Page 12)

E-
8
BASS
MUSIC NORM MOVIE REV HIGH LOW OFF
PHASE AUTO STANDBY OUTPUT TO SPEAKERS
INPUT 1 INPUT 2 FROM AMPLIFIER
/MONO
ON
POWER
OFF
SUPERWOOFER SYSTEM YST–SW800
STANDBY/ON VOLUME0–10 HIGH CUT40–140Hz
STANDBY/ON VOLUME 0–10 HIGH CUT 40–140Hz
1 2 3 4
OUTPUT
TO SPEAKERS
INPUT
1
INPUT
2
FROM AMPLIFIER
BASS
MUSIC NORM MOVIE REV HIGH
LOW
OFF
PHASE AUTO
STANDBY
6 0 7 8
A
/MONO
9
ON
POWER
OFF
5
1
Power indicator
Lights up while the subwoofer is turned on.
2
STANDBY/ON button
Press this button to turn on the power. Press again to
set the subwoofer in the standby mode.
*
This button can be used only when the POWER (
5
)
switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
3
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
*
One graduation of this control represents 10 Hz.
4
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
5
POWER switch
Normally, set this switch to the ON position to use the
subwoofer. In this state, you can turn on the subwoofer
or turn the subwoofer into the standby mode by
pressing the STANDBY/ON (
2 ) button. Set this
switch to the OFF position to completely cut off the
subwoofer’s power supply from the AC line.
6
BASS switch
By setting this switch to the MOVIE position, the bass
sound in video software is faithfully reproduced. By
setting it to the MUSIC position, the bass sound in
audio software is well reproduced.
Rear panel
CONTROLS AND THEIR FUNCTIONS
40Hz
50Hz
60Hz 120Hz
70Hz 110Hz
80Hz 100Hz
90Hz
130Hz
140Hz
Front panel