Yamaha CDC-845 - Manual (Page 21)

1
Select the disc.
2
Load a tape on the tape deck.
* To record from the beginning of the tape, rewind the
tape to the full end of the supply reel.
* The peak level searching function of this unit is useful
for adjusting recording level on the tape deck. (Refer
to page 20.)
3
This unit enters into the pause mode, and the tape deck
enters into the REC/PAUSE mode.
* In this mode, the time display on this unit flashes on
and off.
4
If necessary, select the desired track.
5
Both CD play and tape deck recording begin.
* CD play begins a little later than recording.
Notes
• To finish or stop the recording, make proper operations on
the tape deck.
• Programmed sequence of tracks can also be recorded with
this function, instead of recording an entire disc. (Refer to
page 12–13 for the programming procedure.)
• This function can also be used together with the automatic
tape-programming function.
(Refer to page 17–19.)
21
This unit can make a tape deck’s recording synchronized with CD play automatically. With this function, you can record a CD on
tape very easily and more precisely.
This recording method needs a YAMAHA tape deck compatible with this function. (Refer to the tape deck’s operation manual to
know whether it is compatible or not.)
* This unit and the tape deck must be placed close to each other so that they can receive the signals from this unit’s remote control
transmitter at the same time.
CD SYNCHRONIZED RECORDING
DISC SKIP
SYNCHRO
PLAY
3
1
5
10
MODE 1 2 3
4 5 6
7 8 9 0
+
PLAY PAUSE
SEARCH STOP INDEX
OUTPUT LEVEL + –
SKIP
SYNCHRO
DISC SKIP
DISC
SCAN
4
4
4
SKIP
or