Yamaha CDC-845 - Manual (Page 4)

4
CONNECTIONS
● Before making any connections, switch OFF the power to
the unit and the amplifier or other component.
● Connections should be made to the correct input terminals
of the amplifier or other component.
● If the placement of this unit causes noise to other
equipment, such as a tuner, separate them from each other.
LINE OUT
CD DIGITAL IN
OPTICAL
DIGITAL
AUDIO
OUT
OPTICAL
To AC outlet
This unit
Amplifier
Optical fiber cable
(not included)
When the LINE OUT (analog) terminals of this
unit are used (
➊
)
● Be sure that the left (“L”) and right (“R”) LINE OUT terminals
are connected to the corresponding (left and right) terminals
of the amplifier or other component.
● Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have
such terminals, use the “TAPE PB” terminals. For additional
details concerning these connections, refer to the operation
instructions for the amplifier being used.
● Adjust the level of signals output into an amplifier, etc. by
using the OUTPUT LEVEL control.
When the DIGITAL AUDIO OUT (OPTICAL)
terminal of this unit is used (
➋
)
● Before using this terminal, remove the terminal’s cover by
pulling it.
● Make the connection from this terminal to the digital input
terminal of an amplifier or D/A (digital-to-analog) converter
by using a commercially available optical fiber cable.
● Be sure to attach the terminal’s cover when this terminal is
not being used, in order to protect the terminal from dust.
* Use an optical fiber cable that conforms to EIAJ
standards. Other cables might not function correctly.
● When this terminal is used for the connection, set the
OUTPUT LEVEL control to maximum.
Choose one of the ways listed below to connect this unit to your amplifier.
Connection cord
(included)
➊
➋