ZyXEL Communications ES-2108 - Manual (Page 166)

ES-2108 Series User’s Guide
166 Chapter 27 Introducing the Commands
27.9.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
<T1|T2>lacp Enables LACP for a trunk
group.
interface <port-
list> timeout
<lacp-timeout>
Defines the port number and
LACP timeout period.
vlan <1-4094> Enters the VLAN configuration
mode. See Section 27.9.5 on
page 168 for more information.
vlan-type <802.1q|port-based> Specifies the VLAN type.
vlan1q gvrp Enables GVRP.
ingress-check Enables VLAN tag checking on
incoming traffic.
port-isolation Enables port-isolation.
wrr Sets the switch to use Weighted
Round Robin queuing (WRR).
<wt1 .. wt4> Sets the WRR weight. A weight
value of one to eight is given to
each variable from wt1 to wt4 .
Table 58 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION
Table 59 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
<port-list>
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth control on
the port(s).
egress <kbps> Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress <kbps> Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bmstorm-limit Enables broadcast storm
control on the port.
<Kbps> Sets the limit of broadcast storm
packets in kilobit per second
(Kbps).
diffserv Enables DiffServ on the port(s).
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.