ZyXEL Communications ES-2108 - Manual (Page 188)

ES-2108 Series User’s Guide
188 Chapter 29 IEEE 802.1Q Tagged VLAN Commands
29.2.2 Dynamic Entries (DVLAN Table)
Dynamic entries are learned by the switch and cannot be created or updated by administrators.
The switch learns this information by observing what port, source address and VLAN ID (or
VID) is associated with a frame. Entries are added and deleted using GARP VLAN
Registration Protocol (GVRP), where GARP is the Generic Attribute Registration Protocol.
29.3 Configuring Tagged VLAN
The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the vlan <vlan-id> command to configure or create a VLAN on the switch. The
switch automatically enters the config-vlan mode.Use the inactive command to
deactivate the VLAN(s).
• Use the interface port-channel <port-list> command to enter the config-
interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the exit command when you are finished configuring the VLAN.
Example:
Figure 129 Tagged VLAN Configuration and Activation Example
2 Configure your management VLAN.
• Use the vlan <vlan-id> command to create a VLAN (VID 3 in this example) for
managing the switch, and the switch will activate the new management VLAN.
• Use the inactive command to disable the new management VLAN.
Example:
ras (config)# vlan 2000
ras (config-vlan)# name up1
ras (config-vlan)# fixed 10-12
ras (config-vlan)# no untagged 10-12
ras (config-vlan)# exit
ras (config)# interface port-channel 10-12
ras (config-interface)# pvid 2000
ras (config-interface)# exit