Yamaha MDX-E300 - Manual (Page 25)

23
EnglishEnglish
ADDITIONAL INFORMATION
Display messages
Can’t copy
Digital recording cannot be performed. (See “SCMS -
Serial Copy Management System” on page 22.)
Can’t edit!
Edit operations are not possible.
Can’t REC!
Recording is not possible. The loaded disc may be
protected or there may not be enough blank space
remaining on the disc.
Can’t REC
Recording is not possible. The loaded disc may be
damaged.
DIG in Unlock
No digital signal is being input to the selected digital input
jack.
TMP Over!!
The temperature of the unit has exceeded the normal
operating temperature. Turn off the unit and let it cool
down. If the unit is installed in a place with little
ventilation (such as a built in bookcase), move the unit to
another location with better ventilation.
Disc Full
Recording is not possible because there is no blank space
remaining on the disc.
Title Full!
Additional characters cannot be input for the current title
because the maximum number of characters for a single
title (250) has already been input.
UTOC W Error
Error occurred when writing to the UTOC.
Not Audio
The inserted disc is not an audio MD.
Tr Protected
The selected track cannot be edited because it is protected.
TOC Full
The disc area allotted for TOC data has become full and
further editing is not possible.
UTOC Err L0~4
Problem involving UTOC data.
TOC Writing
The TOC data is being written to the disc. Do not move
the unit or pull out the mains lead. If you do, recorded
material may not be saved normally.
TOC Reading
The unit is reading the TOC data.
Protected
The record protection on the inserted MD is set to
“protect”.
PlayBack MD
The inserted MD is a designed for playback only (you
cannot record on this disc).
Monitor Out
The monitor out function is active. The audio signal input
to the selected input terminals is output from this unit’s
output terminals.
No Track
Blank disc is played or searched.
0107MDXE300(M).21-25.E 02.5.17, 10:54 AM 23