Signal types – Yamaha DME8o-ES User Manual
Page 11
Ref
erences
Other Functions
Connecting to an
External De
vice
A
udio I/O
Connection
Connecting to
a Computer
Contr
ols and
Connector
s
Intr
oduction to
the DME Satellite
Fore
w
o
rd
Introduction to the DME Satellite
DME8i-ES/DME8o-ES/DME4io-ES Owner’s Manual
11
Signal Types
DME Satellite audio system signals can be broadly categorized as follows.
Audio
Analog and digital signals are input and output between the DME Satellite, other DME series units, and other
audio devices. Analog signals are input and output via the [INPUT]/[OUTPUT] jacks. Digital signals are input
and output via the EtherSound jacks.
Control signals within a device group
Device group control signals control all DME series devices in the group.
There are two types of device group control signals, as follows:
•
Control signals between the computer and the group master DME series unit
•
Control signals between the group master DME series unit and the other DME series
units
You can use the DME Designer application to control the entire device group, such as sending components to the
devices and setting the parameters as required.
Control signals between devices outside the device group
These signals provide communication and control between individual devices.
Included in this category are MIDI messages transferred between [USB] connectors, GPI signals transferred be-
tween [GPI] connectors, and remote head amp control signals handled via the [REMOTE] connector.
Type of signals handled by the DME Satellite
Connector
Audio Signal
Device Control
Reference
Page
[USB] Connector
—
• Control signals between computer and DME
Satellite
• MIDI messages
[NETWORK] Connector
—
• Control signals between computer and DME
Satellite
• Control signals between DME Satellites
• Control signals with a controller such as an
AMX or Crestron
EtherSound Connector
Up to 16 channels of input
and output.
• Internal head amp control signals with a
digital mixer
• Control signals with AVS-ESMonitor
[GPI] Connector
—
GPI control signals between GPI device (GPI
controller, etc.) and DME series unit
[REMOTE] Connector
—
• Control signals to/from an external device
(such as AD8HR head amplifier)
• Control signals for a digital mixer and
internal head amp
• Control signals with a controller such as an
AMX or Crestron
• MIDI messages
[INPUT]/[OUTPUT]
Connectors (audio in/out)
The number of I/O channels
depends on model.
—
1
2
3