Yamaha DME8o-ES - Manual (Page 28)

Connecting to an External Device
DME8i-ES/DME8o-ES/DME4io-ES Owner’s Manual
Fore
w
o
rd
Intr
oduction to
the DME Satellite
Contr
ols and
Connector
s
Connecting to a Computer
A
udio I/O
Connection
Connecting to an External De
vice
Other Functions
Ref
erences
28
EtherSound Connection (EtherSound Connectors)
You can use the EtherSound connector to control the DME Satellite’s internal head amp or other functionality.
Controlling DME Satellite’s internal head amps from a digital mixer
The internal head amp settings of a DME8i-ES or DME4io-ES can be remotely controlled from a digital mixer
such as the Yamaha PM5D or DM2000.
Connect the digital mixer using a D-sub 9-pin cable to the AuviTran AVY16-ES interface card, and use Ether-
Sound to make connections between the AVY16-ES and DME series. Use an Ethernet cable connected to the
[NETWORK] connectors to make connections between DME series units.
The gain and the phantom power (+48V) can be controlled from the digital mixer.
NOTE
• Only one mixer can be connected within each device group.
• The digital mixer can be connected to any DME series unit, whether it is the group master or a slave unit.
• Control signal settings are made using AuviTran’s “AVS-ESMonitor” application software.
• The ID number of the DME series unit being remotely controlled is specified from DME Designer.
For details on making this setting, refer to the “DME Designer Owner’s Manual.”
• If the connection between DME series units is broken, it will no longer be possible to communicate with DME units of an
ID number that follows the disconnected DME.
• For details on controlling the head amps from a digital mixer not equipped with a [REMOTE] connector, refer to the
mixer’s owner’s manuals.
Digital Mixer
D-SUB 9-pin
Cable
Ethernet
Straight
Cable
Ethernet Cable
DME8i-ES
DME8i-ES
DME4io-ES
DME4io-ES
Ethernet
Cable
Switching
Hub
EtherSound
Ethernet
Ethernet Switching Hub Hub
AVY16-ES AVY16-ES