6 microsoft networking, Information checklist, Microsoft networking – Xerox WorkCentrePro User Manual

Page 71

Advertising
background image

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide

71

6 Microsoft Networking

This chapter explains how to set up the machine to operate on a Microsoft network. The
following information is provided.

Information Checklist – page 71
SMB Environments – page 72
SMB Installation – page 73
Installation Procedure – page 73
Network Communication Setup – page 73
Workstation Setup – page 75
Test Print – page 75
Changing the Settings – page 75
Procedure – page 75
Setting Format of config.txt – page 76

Information Checklist

Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.

If problems are encountered during the installation, refer to the Problem Solving
chapter
f
or assistance.

CAUTION: Do not connect the network cable to the machine until instructed to
do so.

Item

By

An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.

Customer

Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.

Customer

Test the machine to make sure that it is installed fully and functioning
correctly.

Customer

Install the print driver.

Customer

Advertising
This manual is related to the following products: