Yamaha K-902 - Manual (Page 11)

11
ENGLISH
FRANÇAIS
DEUTSCH
SVENSKA
ITALIANO
ESPAÑOL
DUTCH
REVERSE MODE selector setting (in step 3)
The auto reverse function allows the tape running direction
to be reversed automatically. Select either auto reverse
mode (
) or manual reverse mode ( ).
: When recording on one side of a tape is finished, the
deck stops at the end of the tape.
:Both sides of a tape are recorded. After recording,
the deck stops at the end of the tape.
÷ When the tape running direction is set to ™ , only
the reverse side is recorded.
RELAY : Setting the MODE selector to RELAY
results in the same function as .
Setting the recording level (in step 6)
Play the loudest passage of the source to be recorded and
watch the meter readings.
Adjust the REC LEVEL control so that the highest peak
reaches +4 of the optimum recording level.
DOLBY NR selector setting (in step 2)
Set the DOLBY NR selector according to your purpose.
OFF: No noise reduction.
B: For recording the sources with Dolby B NR.
C: For recording the sources with Dolby C NR.
÷ Dolby noise reduction is an extremely effective method of
reducing undesirable background hiss on tapes. This unit
incorporates both Dolby B NR and the newer Dolby C NR
system. Dolby C NR is approximately twice as effective
as the earlier Dolby B NR.
Display during recording
¤
30 dB –
A
‹
R
L
20 15 10 8 6 4 2 0 2 4 6 +
¤
B
‹
REC
RELAY
B C
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a –30 dB to +6 dB range. There are separate meters
for each left and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds.
Tape counter
Use the tape counter to aid in locating a point on a tape (0000 to 9999).
To set the counter reading to “0000”, press the RESET button.
REC indicator
DOLBY B/ C indicator
MODE indicator Tape running direction indicator
To stop recording:
Press the STOP button. To stop recording temporarily:
Press the REC/PAUSE button. To resume recording, press
the PLAY button.