Xerox 92C - Manual (Page 59)

Network printing environment
System Overview Guide 4-5
Job status feedback
Client workstations display fault messages and additional
information, such as the status of feeder trays and output bins. If
properly configured, the workstations may be able to display job
status, as shown below.
To determine the status of jobs submitted using the lpr
command, you must issue an lpq command at the command line.
Some application software packages may provide a simplified
means of obtaining job status, such as through the use of icons.
Apple
Macintosh Apple OS Optional
Ethernet
interface AppleTalk using
EtherTalk Phase I or
II; none Print directly from
application or use Xerox
DocuPrint Print
Submission Client
software for the
Macintosh.
IBM RS/6000 IBM AIX Standard TCP/IP;
none Print using Xerox Client
Software.
HP/Apollo HP-UX Standard TCP/IP;
none Print using Xerox Client
Software.
Table 4-1. Clients (Continued)
Client
workstation
hardware
Operating
system Ethernet
connection
Protocol;
Translation
requirements
Job submission
method
Table 4-2. Job status feedback
Platform Job status capability
Sun workstation Job status and job deletion are available by issuing the appropriate
command at the command line.
Job status information is available for jobs submitted using Xerox Client
Software.
IBM and compatible
personal computers Job status and job deletion are available depending on the TCP/IP
software installed on the workstation. You must issue the appropriate
command at the command line.
Job status information is available for jobs submitted using Xerox Client
Software.
Job status information is available using the Novell PCONSOLE utility if
the printer is configured with a RPRINTER or PSERVER enabled.
Apple Macintosh Job status information is available at the workstation through AppleTalk.
IBM RS/6000 and HP/
Apollo Job status information is available for jobs submitted using Xerox Client
Software or Ipstat (native utility).