Yamaha E580 User Manual
Page 11
1
Main Level Switch
Normally set to “0 dB”. If desired, you can decrease the main-
channel line output level at the MAIN OUTPUT jacks by 10 dB by
setting this switch to “–10 dB”.
2
Main Output Jacks
Main-channel line output. Connected to input jacks of external
stereo power amplifier (MAIN IN or AUX or TAPE PLAY jacks of
integrated amplifier or receiver).
3
Center Output Jack
Center-channel line output. Can be connected to input jack of an
external power amplifier driving the center speaker.
4
Rear Effect Output Jacks
Rear-channel line output. Can be connected to input jacks of an
external stereo power amplifier driving the rear effect speakers.
5
Center Speaker Terminals
When using the built-in center-channel amplifier, connect the
center speaker(s) here.
6
Rear Effect Speaker Terminals
When using the built-in rear-channel amplifier, connect the rear
effect speakers here.
7
Unswitched AC Outlet
You may plug another component into this socket as long as its
power consumption does not exceed the specified value
shown. “Unswitched” means that power is available even when
this unit is off.
8
Switched AC Outlet (U.S.A., Canada and General Model)
The power consumption of a component plugged into this
socket should not exceed the specified value shown.
“Switched” means that component is turned on and off by this
unit’s power switch.
9
Input Jacks
Accept input from a preamplifier, the “PRE OUT” or “TAPE REC”
outputs from an integrated amplifier, or direct input from a line-
level source.
0
Tape Rec Out and Playback Jacks
Connect the inputs and outputs of a stereo tape deck for
convenient recording and playback via this unit (the effect sound
cannot be recorded).
A
Low Pass Jack
When using a subwoofer, connect its amplifier input to this jack.
Frequencies below 200 Hz from the left main, right main and
center channels are output to this jack.
B
Video Superimpose Input/Output Jacks
Used to display this unit’s current operating status on your video
monitor, superimposed on the picture. Connect the VIDEO OUT
jack to the VIDEO IN jack of your monitor. Connect your
integrated amplifier or control amplifier equipped with video signal
output jacks or video signal source to the VIDEO IN jack.
Alternatively, the S VIDEO OUT and S VIDEO IN jacks can be
used for higher resolution and improved picture quality if your
monitor and video signal source are equipped with S connectors.
9