Technical specifications, Installation instructions, Positioning – Zanussi TCE7227W User Manual

Page 15: Unpacking

Advertising
background image

15

Positioning

It is recommended that, for your convenience, the
machine is positioned close to your washing
machine.
The tumble dryer must be installed in a clean place,
where dirt does not build up.

Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation grille
or the air intake grilles at the back of the machine.

To keep vibration and noise to a minimum when the
dryer is in use, it should be placed on a firm, level
surface.
Once in its permanent operating position, check that
the dryer is absolutely level with the aid of a spirit
level. If it is not, raise or lower the feet until it is.

The feet must never be removed.

Do not restrict the floor clearance through deep-
pile carpets, strips of wood or similar. This might
cause heat build-up which would interfere with
the operation of the appliance.

Unpacking

Warning !

Slide out the polythene bag containing the

polystyrene block before using the appliance.
Pull off adhesive strips from inside machine
on top of drum

Should the appliance be moved, it must be

transported vertically.

P1106

Technical Specifications

DIMENSIONS

Height

85 cm (33.5”)

Width

60 cm (23.6”)

Depth

58 cm (22.8”)

POWER SUPPLY VOLTAGE

240 V/50 Hz

TOTAL POWER ADSORBED

2450 W (13A)

MAX LOAD CAPACITY

Cotton, linen

7

.

kg (13.2 lbs)

Synthetics

3,5 kg (

0

6.6 lbs)

DRUM VOLUME

108 l

CONSUMPTIONS

Cotton, linen

3.95 kWh (7

,

kg store dry)

Cotton, linen

3.05 kWh (7

,

kg iron dry)

Synthetics

1.45 kWh (3,5 kg store dry)

This appliance complies with the following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

Installation Instructions

It is dangerous to alter the specifications or

attempt to modify this product in any way.

Care must be taken to ensure that the appliance

does not stand on the electrical supply cable.

Any electrical work required to install this

appliance should be carried out by a qualified
electrician or competent person.

916096121.qxp 2006-06-02 13:28 Page 15

Advertising