Yamaha RX-495RDS - Manual (Page 17)

Notes
• If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
• RX-495RDS and RX-395RDS only
When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs PS data service is received, the frequency is then
replaced by the station name. Refer to page 24 for details.
17
English
1
Select the reception band (FM or AM) confirming it on
the display.
2
3
Tune to a desired station manually.
* To continue tuning search, press and hold the button.
FM/AM
FM AM or
1
Select the reception band (FM or AM) confirming it on
the display.
2
3
To tune to a higher frequency, press the right side once.
To tune to a lower frequency, press the left side once.
* If the station where tuning search stops is not the desired
one, press again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.
TUNING OPERATIONS
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
AUTOMATIC TUNING MANUAL TUNING
FM/AM
TUNING MODE
AUTO/MAN'L MONO
TUNING MODE
AUTO/MAN'L MONO
TUNING DOWN UP
TUNING DOWN UP
AUTO AUTO TUNING
Turn “AUTO (TUNING)”
off.
FM AM or
1 3 2
RX-495RDS,RX-395RDS RX-395