Yamaha RX-SL80 - Manual (Page 28)

24
TUNING
■ Automatically presetting FM stations
You can use the automatic preset tuning feature to store
FM stations. This function enables this unit to
automatically tune in to FM stations with strong signals,
and to store up to 40 (8 stations x 5 groups) of those
stations in order. You can then recall any preset station
easily by selecting the preset station number.
1
Press INPUT, then rotate VOLUME/SELECT
within 5 seconds to select TUNER.
If no operation is performed within 5 seconds of pressing INPUT
or VOLUME/SELECT is pressed on the front panel, the function
of VOLUME/SELECT switches back to volume level adjustment.
If this happens, “VOLUME” appears in the front panel display for
a few seconds.
2
Press INPUT repeatedly on the front panel to
select the FM band you want to preset.
“FM” appears in the front panel display.
3
Hold down VOLUME/SELECT for more than
5 seconds.
The “AUTO” and “MEMORY” indicators flash in the
display and after about 5 seconds, automatic
presetting starts from the lowest frequency,
proceeding to higher frequencies.
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
• Any stored station data existing under a preset number is
cleared when you store a new station under that preset number.
• If the number of the received stations does not reach E8,
automatic preset tuning automatically stops after searching all
stations.
• Only FM stations with sufficient signal strength are stored
automatically by automatic preset tuning. If the station you
want to store is weak in signal strength, tune in to it manually in
the monaural mode, and store it by following the procedure in
“Manually presetting stations”.
Presetting stations
Note
INPUT
VOLUME/SELECT
DSP TUNER
AUTO/MAN'L
PUSH-ENTER
STANDBY /ON SILENT CINEMA VIDEO AUDIO
VIDEO 2 PHONES
OPTICAL L R
VOLUME/SELECT INPUT
VOLUME/SELECT
INPUT
INPUT
Notes
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the preset stations may be cleared. If
so, store the stations again by using the presetting
station methods.
VCR
AUTO MEMORY
VOLUME
L L R
VIDEO 1 VIDEO 2 DTV/CBL TUNER DVD/CD