Yamaha RX V2095RDS - Manual (Page 23)

21
English
Speakers
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
CENTER FRONT
CAUTION
MAIN CENTER FRONT REAR
( SURROUND ) PRE
OUT MAIN
IN
SPEAKERS
COUPLER OUTPUT
A
B
A
B
REAR
MAIN
IMPEDANCE SELECTOR
CENTER : 4 Ω MIN. / SPEAKER
FRONT : 6 Ω MIN. / SPEAKER
REAR : 6 Ω MIN. / SPEAKER
MAIN A OR B: 4 Ω MIN. / SPEAKER
A B : 8 Ω MIN. / SPEAKER
CENTER : 8 Ω MIN. / SPEAKER
FRONT : 8 Ω MIN. / SPEAKER
REAR : 8 Ω MIN. / SPEAKER
MAIN A OR B: 8 Ω MIN. / SPEAKER
A B : I 6 Ω MIN. / SPEAKER
SUB
WOOFER
( SURROUND )
SET BEFORE POWER ON
Center speaker
Front effect speakers
Left Right
Left Right
Main speakers A
Rear speakers
Subwoofer system
Left Right Left Right
Use speakers with the specified impedance shown on the rear of this unit.
Red: positive (+)
Black: negative (–)
➀ Loosen the knob.
➁
Insert the bare wire.
[Remove approx. 5mm
(1/4”) insulation from
the speaker wires.]
➂
Tighten the knob and
secure the wire.
1
2
3
How to Connect:
Connect the SPEAKERS terminals to your speakers with the
wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires is
correct. That is the + and – markings are observed. If these
wires are reversed, the sound will be unnatural and lack bass. Caution
Do not let the bare speaker wires touch each other or any
metal part of this unit. This could damage this unit or the
speakers, or both.
PREPARATION
Main speakers B