Yamaha RX V2095RDS - Manual (Page 26)

24
Antennas
● Each antenna should be connected to the designated terminals correctly, as shown in the following figure.
● Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal
strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor
reception quality only with the indoor antennas, the use of an outdoor antenna may result in improvement.
PHONO
1
CD
AUDIO SIGNAL
GND
CD CD DVD/LD TAPE/MD
IN
(PLAY)
OUT
(REC)
EXTERNAL
DECODER
INPUT
TAPE/MD
3
4
IN
( PLAY )
OUT
( REC )
MAIN
SUB WOOFER CENTER
SURROUND
DIGITAL
RF SIGNAL
COAXIAL DIGITAL SIGNAL
75 Ω
UNBAL.
AM
ANT
FM
ANT
GND
Outdoor FM antenna
Outdoor AM antenna
AM loop
antenna
(included)
Ground
75-ohm/300-ohm
antenna adapter
75-ohm coaxial cable
300-ohm flat ribbon
cable
Indoor FM
antenna
(included)
Ⅵ
Connecting the AM loop antenna
1. Press the tab and unlock the terminal hole.
2. Connect the AM loop antenna lead wires to the AM ANT and
GND terminals.
3. Return the tab back to the original position to lock the lead
wires. Lightly pull on the lead wires to confirm a good
connection.
4. Attach the loop antenna to the antenna stand.
5. Orient the AM loop antenna so that the best reception is
obtained.
Notes
● The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
● The AM loop antenna should be kept connected, even if an
outdoor AM antenna is connected to this unit.
1
3
2
Loop antenna
Antenna stand
PREPARATION
(Europe model)
75-ohm/300-ohm
antenna adapter