ZyXEL Communications ZyXEL ZyWALL P1 - Manual (Page 61)

ZyWALL P1 User’s Guide
60 Chapter 3 Wizard Setup
Figure 16 VPN Wizard: Gateway Policy Setting
The following table describes the labels in this screen.
3.3.6 VPN Wizard: Network Setting
Use the second VPN wizard screen to configure the settings for each LAN network behind the
ZyWALL and the remote VPN router.
Two active SAs cannot have the local and remote IP address(es) both the same. Two active
SAs can have the same local or remote IP address, but not both. You can configure multiple
SAs between the same local and remote IP addresses, as long as only one is active at any time.
Table 12 VPN Wizard: Gateway Policy Setting
LABEL DESCRIPTION
Gateway Policy Property
Name Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
Gateway Policy Setting
My ZyWALL Enter the WAN IP address or the domain name of your ZyWALL. The ZyWALL uses
its current WAN IP address (static or dynamic) in setting up the VPN tunnel if you
leave this field as 0.0.0.0.
The ZyWALL has to rebuild the VPN tunnel if the IP address changes after setup.
Remote
Gateway
Enter the WAN IP address or the domain name of the IPSec router with which you're
making the VPN connection. Set this field to 0.0.0.0 if the remote IPSec router has a
dynamic WAN IP address.
Next Click Next to continue.