ZyXEL Communications ZyXEL ZyWALL P1 - Manual (Page 85)

ZyWALL P1 User’s Guide
84 Chapter 5 WAN Screens
Figure 27 WAN: WAN: PPPoE
The following table describes the labels not previously discussed.
Table 23 WAN: WAN: PPPoE
LABEL DESCRIPTION
ISP Parameters
for Internet
Access
Encapsulation The PPPoE choice is for a dial-up connection using PPPoE. The router supports
PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF Draft standard
(RFC 2516) specifying how a computer interacts with a broadband modem (i.e.
DSL, cable, wireless, etc.) connection. Operationally, PPPoE saves significant effort
for both the end user and ISP/carrier, as it requires no specific configuration of the
broadband modem at the customer site. By implementing PPPoE directly on the
router rather than individual computers, the computers on the LAN do not need
PPPoE software installed, since the router does that part of the task. Further, with
NAT, all of the LAN's computers will have access.
Service Name Type the PPPoE service name provided to you. PPPoE uses a service name to
identify and reach the PPPoE server.