Yamaha CLP-123 User Manual

Page 22

Advertising
background image

76

4

V

Attach the side panels (D) to the pedal
box (C).

Before installing the pedal box: remove the bundled

cord from the bottom of the pedal box, remove the plastic
cover and cord binder, then straighten out the cord.

Place the pedal box on top of the brackets attached to the

side panels (D), and attach using the four long black
screws

3 on each side. Make sure the pedals extend in the

same direction as the feet.

B

Install the main unit (A).

Rest the rear edge of the main unit (A) on the front

edges of the cutouts in the side panels (D), then slide the
main unit backward firmly until it stops (so that there is no
clearance between the main unit side panels and the stand,
as shown in the illustration “a”). WATCH YOUR FIN-
GERS WHEN DOING THIS!!
There is slight horizontal
play between the main unit and side panels, so center the
main unit, as shown in the illustration “b”, then attach the
main unit with 6 short black screws

2.

V

Schrauben Sie den Pedalkasten (C) an
den Seitenwänden (D) fest.

Vorbereitender Schritt: Zunächst nehmen Sie das im

Pedalkasten gebündelte Kabel heraus, entfernen die
Kunststoffabdeckung sowie den Kabelbinder und ziehen
das Kabel dann gerade aus.

Setzen Sie den Pedalkasten auf die Winkelbleche der

beiden Seitenwände (D), und schrauben Sie ihn dann mit
den vier langen schwarzen Schrauben

3 an beiden Seiten

fest. Achten Sie dabei darauf, daß die Pedale in dieselbe
Richtung weisen wie die vorspringenden Teile der Füße.

B

Montieren Sie die Tastatureinheit (A).

Setzen Sie die Hinterkante der Tastatureinheit (A) auf

die ausgeschnittenen Ecken der beiden Seitenwände (D),
und schieben Sie die Tastatureinheit dann bis zum
Anschlag nach hinten (zwischen der Tastatureinheit und
den Seitenwänden darf an dem in Abbildung “a” gezeigten
Punkt kein Zwischenraum verbleiben). KLEMMEN SIE
IHRE FINGER DABEI NICHT EIN!!
Die
Tastatureinheit hat zwischen den beiden Seitenwänden
etwas Spiel. Richten Sie die Tastatureinheit gemäß
Abbildung “b” mittig aus, und machen Sie sie dann mit
sechs kurzen schwarzen Schrauben

2 fest.

Advertising