SINBO SJ 3129 - Manual (Page 15)

- 14 -
ATTENTIONS
who have the responsibility for security. Children should be overseen, so it
can be testified that they are not playing with it.
2. Before using, put this machine on a stable and even table board, operate
according to the above methods.
3. Before juicing, first confirm juicing net and rotor clutched in position, and
no hard contact between juicing net cutter and transparent cover. Put the
transparent cover on, fasten tight the handle, then turn on the machine.
4. Before being used, the motor works in running-in phase, there may be
slight peculiar smell and spark, this is normal, after the motor works for some
period, the above phenomenon will disappear.
5. During juicing, make sure there is not too full juice and residue in the middle
seat and residue cup, if too full, please cut off power supply, clean up, then
use again.
6. During using, do not open the cup cover. In case power supply is on, do not
put hand or any ware into the mixing cup or feed port, otherwise, harmful
accident may occur or this machine may be damaged.
7. In order to prolong service life of this machine, over-temperature protective
device is mounted in the motor. If the motor works for a long time or overloaded,
when over warning temperature, power supply will automatically cut off. After
the motor stops, pull out plug of power supply, wait for the motor to cool
(about for 30 min), use again.
8. All fittings are strictly prohibited from disinfecting in high temperature
disinfection cabinet or steaming and boiling for disinfection.
9. During operating, please do not leave, never let children operate this
machine.
10. When this machine works in mixing, mincing or grinding conditions, no-
loaded or over loaded work is strictly prohibited.
11. After operation, do not pour the food out until pull out the plug of power
supply.
12. Cutters are very sharp, in order to avoid danger, when cleaning a cutter,
please put the cutter under water tap for washing, do not wash it with hand.
13. This machine must not be used for others beyond regulated purposes.
14. In case of damaged power supply cord, in order to avoid danger, replacement
must be performed by the manufacturer or its service department or similar