Yeoman YM-CKWDBL-R - Manual (Page 17)

MAINTENANCE and SERVICING
17
1. GENERAL CLEANING
1.1 We would recommend that your Solid fuel cooker be
cleaned fully on a regular basis, according to the level of
use. Attention should be given to cleaning the flueways
and removing ash. Regular cleaning and preventive
maintenance will help give many years of safe use.
1.2 Flue ways under the oven may be cleaned by removing
covers as shown.
After removing the outer cover by pulling free from the
sprung retaining clips the inner cover can be removed
after unscrewing the two, wingnut fixings. Care should
be taken not to damage any seals. If seals are damaged
they should be replaced before cooker is re-used.
1.3 The external finish may be cleaned using warm soapy
water and a soft clean cloth. Wipe dry with a soft clean
cloth before re-lighting. Do not leave unit without
drying, as this may cause rust.
2. CLEANING GLASS
2.1 While the correct use will generally keep the glass clean
when the appliance is used you may sometimes need to
clean the glass.
2.2 This can be done as follows. Allow the Solid fuel cooker
to cool fully, never attempt to clean hot glass. Any
deposits can be removed using a soft cloth and Stovax
Glass Cleaner. Then wipe with warm soapy water and a
cloth, to neutralise any remaining cleaner, and finish
with a soft dry cloth.
2.3 Before re-lighting the appliance, dry the glass fully.
2.4 Do not use abrasive cleaner or cleaning pads.
3. CHIMNEY SWEEPING
3.1 We would recommend that to maintain the safe and
efficient use of the appliance the flue / chimney is
inspected and swept at least once a year, by a NACS
registered (UK only) chimney sweep, to confirm that
the system is clean, structurally sound and free from any
obstructions.
4. ANNUAL SERVICE
4.1 Once a year it is recommended to inspect and clean the
cooker as detailed: -
4.2 Carefully remove all of the following internal parts.
Complete grate and ashpan, and vacuum clean any
remaining ash and debris from the inside of the cooker.
4.3 The coloured surfaces of the cooker are finished in
vitreous enamel. Care should be taken as this finish can
be damaged by cleaning with metal scrapers or wire
wool. Burnt-on food may be removed by carefully using
a plastic scraper or plastic cleaning pad. Use hot soapy
water and a cloth to clean and finish with a soft dry
cloth.
4.4 The internal surfaces of the oven are finished with
vitreous enamel. These may be cleaned using a non-
abrasive oven cleaner and any burnt-on food may be
removed by carefully using a plastic scraper or plastic
cleaning pad. Use hot soapy water and a cloth to clean
and finish with a soft dry cloth.
4.5 The door glass may be cleaned by using Stovax glass
cleaner and a soft cloth. Then wipe with warm soapy
water and a cloth, to neutralise any remaining cleaner,
and finish with a soft dry cloth.
4.6 Clean the Grate parts with a wire brush, check for any
damage and replace any damaged parts as required.
4.7 Check and clean, with a soft brush the Firebricks.
Replace any broken bricks. It is normal for some surface
damage to occur during use.
4.8 Re-fit cleaned internal parts.
Inner Cleaning Cover
Outer Cleaning Cover