X10 Wireless Technology MS18A - Manual (Page 2)

Battery Replacement
If a zone has not reported in during the last four hours, the display will show
PROBLEM. This is most likely caused by dead batteries.
As long as the batteries have not completely failed they can be replaced with fresh
batteries without the need to reinstall the Motion Detector. After removing the old
batteries fresh batteries must be fitted within 30 seconds to ensure that the security
code is retained.
To test the Motion Detector:
Once the batteries have been replaced, the Motion Detector should be tested as
follows:
• Make sure the system is NOT armed.
• Press the TEST button on the back of the Motion Detector. The Console chimes to
acknowledge and the zone # is displayed on the LCD.
If the batteries had failed, the security code will have been lost. You will need to
reinstall the Motion Detector following the directions in this instruction sheet.
FCC Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: NO CHANGES OR MODIFICATIONS MAY BE MADE TO THE UNITS.
ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHOR-
ITY TO OPERATE THE EQUIPMENT.
Please visit: http://www.x10.com/support for additional help and warranty
conditions.
Also see www.x10.com for more accessories that work with your Security
System, including Lamp Modules and Wall Switch Modules to flash lights
when the alarm trips, and remote controls that let you remotely control lights
(and appliances) connected to X10 Modules.
The X10 Supervised Security System includes a Security Console with an automatic
dialer that calls friends or relatives in the event of a break in. Accessories include
battery powered Radio Frequency (RF) Door/Window Sensors, battery powered RF
Motion Detectors, and RF Keyfob Remote Controls for arming and disarming the
system. All sensors and remotes incorporate random digital security coding.
The system can be configured with any combination of the following items:
• Up to 16* Wireless Keyfob Security Remotes with arm/disarm and panic
functions, and buttons to control security lights in and around the home.
• Up to 30* magnetic switch operated Wireless Door/Window Sensors.
• Up to 30* Wireless PIR Motion Detectors.
• Optional X10 Home Automation modules such as plug-in lamp and appliance
modules and wired-in replacement wall switches can be added to the system.
The Owner’s Manual for the Security System describes the full installation process
for the Security System, and should be referred to as a supplement to this instruction
sheet.
*Note: Door/Window Sensors and Motion Detectors may be added in any
combination up to a total of 30, e.g. 15 Door/Window Sensors and 15 Motion
Detectors, or any combination up to a total of 30 . There are also 2 hard wired
inputs, which are zones 31 and 32.
X10 Wireless Technology, Inc. Kent WA 98032
Motion Detector
Model MS18A
MS18A-1/05