Yamaha RXV2092 - Manual (Page 38)

34
Switching the IMPEDANCE SELECTOR switch on the
rear panel
Select the position whose requirements your speaker system
meets. Be sure to switch this only when the power of this unit is
turned off.
(Upper position)
Center: If you use one center speaker, the impedance of the
speaker must be 4
Ω
or higher.
If you use two center speakers, the impedance of each
speaker must be 4
Ω
or higher.
Rear: (U.S.A. and Canada models:)
The impedance of each speaker must be 4
Ω
or higher.
(Australia, Singapore and General models:)
The impedance of each speaker must be 6
Ω
or higher.
Main: If you use one pair of main speakers, the impedance of
each speaker must be 4
Ω
or higher.
If you use two pairs of main speakers, the impedance of
each speaker must be 8
Ω
or higher.
Front effect:
The impedance of each speaker must be 6
Ω
or higher.
WARNING
Do not change the IMPEDANCE SELECTOR switch setting
while the power to this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE POWER
SWITCH IS PRESSED
The IMPEDANCE SELECTOR switch may not be set to either
end closely. If so, set the switch to either end closely.
(Lower position)
Center: If you use one center speaker, the impedance of the
speaker must be 8
Ω
or higher.
If you use two center speakers, the impedance of each
speaker must be 4
Ω
or higher.
Rear: The impedance of each speaker must be 8
Ω
or higher.
Main: If you use one pair of main speakers, the impedance of
each speaker must be 8
Ω
or higher.
(Except Canada model:)
If you use two pairs of main speakers, the impedance of
each speaker must be 16
Ω
or higher.
Front effect:
The impedance of each speaker must be 8
Ω
or higher.
(General model)
A
B
SWITCHED AC OUTLETS
IMPEDANCE SELECTOR
VOLTAGE SELECTOR
I20V
60Hz
I00W
MAX.
TOTAL
CENTER C OR D: 4 Ω MIN./ SPEAKER SET SPEAKER MODE C D: 4 Ω MIN./ SPEAKER SET SPEAKER MODE REAR 6 Ω MIN./ SPEAKER MAIN A OR B: 4 Ω MIN./ SPEAKER A B: 8 Ω MIN./ SPEAKER FRONT EFFECT: 6 Ω MIN./ SPEAKER
CENTER C OR D: 8 Ω MIN./ SPEAKER SET SPEAKER MODE C D: 4 Ω MIN./ SPEAKER SET SPEAKER MODE REAR 8 Ω MIN./ SPEAKER MAIN A OR B: 8 Ω MIN./ SPEAKER A B: 6 Ω MIN./ SPEAKER FRONT EFFECT: 8 Ω MIN./ SPEAKER
IMPEDANCE
SELECTOR