Yamaha RXV2092 - Manual (Page 55)

51
English
To store stations
1. Tune to a desired station.
(Refer to the previous page for tuning procedure.)
2. Select a desired group (A – E) of preset stations confirming it
on the display panel.
3. Press the MEMORY button.
4. Select a preset station number where you want to program the
station before “MEMORY” goes off from the display.
• In the same way, program other stations to A2, A3 ... A8.
• You can program more stations to preset station numbers on
other groups in the same way by selecting other groups in step
2.
To recall a preset station
1. Select the group of preset stations.
2. Select the preset station number.
NOTES
•
A new setting can be programmed in place of the former one.
• For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data from
being lost even if the POWER switch is set off or the power plug is
disconnected from the AC outlet or the power is cut due to
temporary power failure. If, however, the power is cut for more
than one week, the memory may be erased. If so, it can be re-
programmed by simply following the PRESET TUNING steps.
PRESET TUNING
Press once or more.
Press once or more.
Shows the displayed station
has been programmed to A1.
MAN’L/AUTO FM
MEMORY
MEMORY
A/B/C/D/E
PRESET
MANUAL PRESET TUNING
This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only
selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored.
Front panel
Front panel
Front panel
Front panel
Front panel
PRESET
MHz FM
STEREO
0 20 l00 ROOM 2 CONTROL 40 60
SPEAKERS AUTO TUNING
A
SPEAKERS
B
ROOM 2
1 2 3 4 5 6 7 8
A/B/C/D/E
1 2 3 4 5 6 7 8
Flashes on and off for
about 5 seconds.