Yamaha CC-70S - Manual (Page 31)

General information
•
Do not use C-120 tapes, tapes with internal reels or poor-
quality tapes, since they can cause malfunctions.
•
Before loading a tape into the cassette compartment,
tighten the slack tape with a pen or pencil.
•
Tapes have removable tabs which prevent accidental
recording or erasing from taking place. Removing the tab
on the top left protects the side facing you from erasure.
Cover the tab holes with adhesive tape to erase or record
again.
• This deck is a Single Cassette Deck with Automatic
Reverse Function.
• This deck features an auto tape selector. Just load the
tape, and the tape formula being used will be sensed
automatically.
• This unit can play back metal tapes as well as normal or
chrome tapes, and recording can also be done on metal
tapes.
• When covering erasure prevention tab holes, do not cover
the chrome and metal detection holes. Otherwise, the
deck will treat tape as normal tape.
• Do not press the OPEN/CLOSE button during playback or
recording.
Tape playback
1
Press the TAPE input selector button.
2
Open the cassette compartment by pressing the
OPEN/CLOSE button.
3
Load the tape into the cassette compartment.
4
Set the Dolby NR switch to B or C if the tape has been
recorded with Dolby noise reduction, and to OFF if Dolby
NR was not used.
*
For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 30.
5
Set the reverse mode switch as desired.
The reverse mode switch can be operated before or during
playback, and changes tape playback as follows:
6
Press the play button to listen to side A, or the play
button for side B.
29
Detection hole
Tab
TAPE DECK OPERATION (for KX-S90 Single Cassette Deck)
Side A only
Side B only
Side A
→
Side
B
Side B only
Side A
→
Side B
Continuous play
(8 times)
Side B → Side A
Continuous play
(8 times)
EMPTY
Receiver
Tape Deck
1
3
6 6 4 5 2
Side A upward.