Zanussi ZDF490 - Manual (Page 11)

11
FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is switched
off at the wall before any further work is carried
out.
·
Using a tape measure establish the internal
width of the cabinet. Refer to page 7 if greater
than 565mm.
·
Position the appliance in front of the cabinet.
See Fig. 7.
·
Take out all oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed
whilst lifting.
·
To place the appliance into the cabinetry follow
the procedure below:
·
N.B. Two people will be required to carry
out the lifting procedure.
·
Do not try to lift or move the appliance by
pulling the door handles.
a) Each person should squat either side of the
appliance.
b) Tilt the appliance so that your hands can
support the underside of the appliance.
c) Keeping your back straight, raise the appliance
to the cabinet by straightening at the knees.
d) Rest the rear underside of the appliance on the
cabinet floor while your hands support the
front.
e) The appliance can be pushed fully into the
cabinet. Take care to avoid fouling the mains
lead.
f) Ensure the appliance is central in the cabinet
and level.
g) Do not remove spacers fitted behind fixing
holes.
h) When the appliance is fully housed screw the
stability screws (supplied with the appliance)
into the side of the cabinet taking care not to
distort the side trims (See Fig 8). It is
advisable to turn each screw alternatively to
avoid damaging the trims.
i) Switch on the appliance then refer to the
operating instructions in the following pages.
Fig. 7
Fig. 8