Cleaning between the outer and inner door glass – Zanussi ZDF490 User Manual

Page 29

Advertising
background image

29

CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE

All removable parts, except the grill pan handle, can
be washed in the dishwasher.

The meat tin, grill pan, grill pan grid, oven shelves
and wirework runners may be cleaned using a soap
impregnated steel wool pad. Soaking first in hot
soapy water will make cleaning easier.

TO REMOVE THE WIREWORK RUNERS

The wirework runners in the grill and oven
cavities can be removed for cleaning.

1. Remove all shelves and furniture from the grill

and oven compartments.

2. Hold the wirework at the bottom, unclip from the

cavity side and gently pull towards the centre of
the grill or oven compartment.

3. Unhook the runner at the top and remove from

the cavity.

4. To replace, hook the wirework runner back into

the grill/oven sides.

Ensure that the wirework runners are firmly
in place before refitting the oven shelves.

CLEANING BETWEEN THE OUTER AND
INNER DOOR GLASS

To prevent damaging or weakening the
door glass panels avoid the use of the
following:
· Household detergents and bleaches
· Impregnated pads unsuitable for non-

stick saucepans

· Brillo/Ajax pads or steel wool pads
· Chemical oven pads or aerosols
· Rust removers
· Bath/Sink stain removers

Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.

The outer door glass is removable for cleaning.

TO REMOVE THE OUTER GLASS

1. Open the oven door slightly to gain access to the

two cross head screws on the top of the oven
door.

2. Loosen the two screws using a Pozidrive

screwdriver.

3.

Hold the door glass securely in place with one
hand before removing the screws completely
with the other hand.

4. Using both hands, gently tilt the top of the door

glass towards you, lift slightly to disengage the
locators from the two bottom brackets. The door
will remain in a parked position at an angle of
approximately 30°C.

5.

Clean the outer and inner glass using hot soapy
water or Hob Brite may be used with care. DO
NOT
use Hob Brite on the Stainless Steel or
painted finishes. DO NOT try to clean the foil
which is inside the door. The foil is there to help
keep the door cool, if it is damaged it will not
work. Ensure that all parts are well rinsed and
thoroughly dried before attempting to replace
the outer door.

If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Centre
who will be pleased to advise further.

SIDE PANEL

CAVITY CENTRE

Grill Door Trim

Advertising