Zoom G2.1NU - Manual (Page 26)

26 ZOOM G2Nu/G2.1Nu
1. Connect a foot switch (FS01) to the
CONTROL IN jack.
2. Press the USB/GLOBAL key to light it and
open the GLOBAL menu.
3. Use the effect type [▼]/[▲] keys to select
"FootSwitch."
4. Turn Parameter knob 1 to set the foot
switch function.
The foot switch can be set to one of the following
functions.
BP/MT Set the unit to bypass/mute.
BANK UP Increase the bank number by one
with each press of the foot switch.
RHYTHM Turn Rhythm mode ON/OFF.
BPM TAP Set the tempo used for the rhythm,
looper and effect by pressing the
foot switch repeatedly at the
desired tempo.
DL TAP Set the Time parameter of the
DELAY module by pressing the
foot switch repeatedly.
DL HOLD Turn hold delay ON/OFF. Hold
delay is a function that allows the
delay sound to be repeated without
decay (see the illustration below).
DL MUTE Turn the DELAY module's input
mute ON/OFF.
To use DL TAP, DL HOLD or DL MUTE, you
must turn the DELAY module ON.
5. After making the setting, press the USB/
GLOBAL key again to turn its light out.
HINT
The foot switch function setting affects all
patches. Moreover, this setting is saved even
when the power is turned OFF.
Using a Foot Switch
You can connect an optional foot switch to the CONTROL IN jack, and use it to control additional settings of the unit
with your feet, for example, by changing banks and operating effects.
Sound
source
Delay sound
Press the foot switch
Hold delay
Hold
Press again
HINT
Foot switch function