Yamaha CVP-207 EN - Manual (Page 137)

Making Global and Other Important Settings — Function
137 CVP-209/207
The explanations here apply to step #3 of the procedure on page 133.
Setting Song-related Parameters — Song Settings
Quick Start
On some commercially avail-
able song data, certain set-
tings related to the song
(such as voice selection, vol-
ume, etc.) are recorded to
the first measure, before the
actual note data. When
Quick Start is set to “ON,”
the CVP-209/207 reads all
initial non-note data of the
song at the highest possible
speed, then automatically
slows down to the appropri-
ate tempo at the first note.
This allows you to start play-
back as quickly as possible,
with a minimum pause for
reading of data.
n
Channel
Refers to the MIDI channel
(page 158). The channels
are assigned as follows:
Song
1 - 16
Accompaniment Style
9 - 16
n
The guide lamps light in
response to song channel
assigned to Tracks 1 and 2,
as well as chord data (when
contained in the song). Nor-
mally, you can leave the
AUTO SET CH function set
to ON, and the song channel
will automatically be set. If
the results aren’t satisfac-
tory, you’ll need to match the
Channel Setting “TRK1 CH”
and “TRK2 CH” parameters
to the appropriate right- and
left-hand parts.
n
Phrase Mark
This data specifies a certain
location in the song data.
A
E
D
C
B
F
J
I
1 2 3 4 5 6 7 8
H
G
Determines the Guide
method.
Turns guide lamps ON or
OFF.
Determines the timing for the guide
lamps.
JUST ........ The guide lamps light
precisely at the moment
you should play.
NEXT ........ The guide lamps light just
before the moment you
should play. If you miss the
proper timing, the guide
lamps flash.
Turns Quick Start on/off (see note).
Allows you to play back all songs
from the same folder continuously.
Determines the MIDI channel assigned
to the [TRACK2] button.
Determines the MIDI channel assigned
to the [TRACK1] button.
When set to “ON,” this
automatically sets the proper
Track 1 and Track 2 channels for
use with the practice functions.
Normally, this should be set to
“ON.”
Determines the language of the
displayed lyrics.
When this is set to “AUTO,” the
language defaults to that of the
song data. When not set to
“AUTO,” the language defaults to
Japanese, when the internal
setting (page 151) is
“JAPANESE”; for all other
languages, this is set to
“INTERNATIONAL.”
Determines whether the Phrase
Mark Repeat function for the song
is on or off. When this is on, you
can repeatedly play back a
specified phrase (selection of
measures) of the song. The
method for setting a phrase mark
is the same as that in the SONG
POSITION display (page 77).
Determines the harmony channel for
Vocoder (page 131).