Yeoman CL MILNER BRICK YMMB - Manual (Page 9)

9
7. ASH REMOVAL
Do not allow ash to build up in the appliance as it will
not burn properly and may cause damage.
7.1 Wood
—Open doors and using gloves remove ashpan with the tool
provided (see Diagram 10).
—Remove ash and place into a Yeoman Ash Caddy
(Yeoman Part No. 4227) or other suitable container.
Do not place hot ash in any container made from plastic
or any other combustible material.
—De-ash at least once a week or when ashpan is full.
PR9033
10
Ashpan
7.2 Multi-fuel:
—De-ash the appliance before filling with new fuel. Do not
allow ash to build up on the underside of the grate as this
can cause premature failure.
—Riddle (see Diagram 11).
Riddling
Handle
PR9035
11
—Remove ash and place into a Yeoman Ash Caddy
(Yeoman Part No. 4227) or other suitable container.
Do not place hot ash in any container made from plastic
or any other combustible material.
—De-ash at least once a week or when ashpan is full.
USER INSTRUCTIONS
8. EXTENDED BURNING
8.1 It is possible to get the appliance to burn for extended
periods of time. In order to do this:
—De-ash prior to final refuelling.
—Set air controls to low combustion settings.
This will gradually blacken the glass but it will clear when
operated at a high temperature for a short period.
—Use smokeless fuel or small, thick logs.
9. OVER-FIRING
9.1 Do not over-fill with fuel or run at high temperatures for
long periods or over-firing can occur. If the flue pipe, flue
collar or top plate glow red the appliance is over-firing.
Close the air controls to reduce the temperature.
9.2 Over-firing can cause permanent damage to the
appliance and invalidate the product warranty.
WARNING: DO NOT OPERATE THE APPLIANCE WITH
THE PRIMARY AIR CONTROL OPEN FOR LONG
PERIODS OF TIME AS THIS COULD CAUSE OVER-
FIRING AND MAY CAUSE PERMANENT DAMAGE.
10. CHIMNEY FIRE
10.1 If a chimney fire occurs:
—Shut all air controls immediately.
—Evacuate the building.
—Call the fire brigade.
—Do not re-enter the building until it is confirmed safe.
10.2 Do not use the appliance after a chimney fire until:
a) It has been inspected by a registered installer* who
has confirmed the appliance is safe to use.
b) The chimney system has been inspected and swept by a
chimney sweep, confirming the system is structurally sound
and free from obstruction**.
c) It is repaired as required before re-use. Use only
genuine Yeoman replacement parts to keep your appliance
in safe, efficient working order.
* Registered on the Competent Persons Scheme (GB only)/
INFO (Republic of Ireland only) see page 25 for details.
**This should be done by a HETAS Approved Chimney
Sweep (UK only)/INFO registered (Republic of Ireland only)
see page 26, who will issue you with a certificate.