Yamaha HTR-5140RDS - Manual (Page 29)

29
English
TO RECORD A SOURCE ON TAPE OR MD
1
Select the source to be recorded.
Front panel Remote control
or
2
Play the source and then turn up the volume to confirm
the program source. (See page 30 for detailed
information on tuning.)
Front panel Remote control
or
3
Begin recording on the tape deck, MD recorder or VCR
connected to this unit.
4
When a tape deck or MD recorder is being used for
recording, you can monitor the sounds being recorded
by pressing TAPE/MD MON / EXT. DECODER on the
front panel or TAPE/MD on the remote control
transmitter so that the “TAPE/MD MON” indicator lights
up on the display.
Front panel Remote control
or
Notes
• The settings of DSP and VOLUME, BASS, TREBLE and
BALANCE have no effect on the material being recorded.
• A source that is connected to this unit only through the digital
terminals cannot be recorded by a tape deck, MD recorder or
VCR connected to this unit.
• Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of
copyright material may infringe copyright laws.
If you use a video source that has scrambled or encoded
signals to prevent it from being dubbed, there may be a case
that the picture itself will be affected by those signals.
4 2 1
2
1,4
01RX-V495RDS-3 6/22/99, 12:27 PM 29