Zebra Technologies A300 - Manual (Page 29)

Zebra )300 User’s Guide
Troubleshooting Modes
Printing a Configuration Label.
To print out a listing of the printer’s
current configuration (configuration label), refer to Table 1, “Feed Key
Troubleshooting Modes,” on page 14.
Calibration.
If the printer is exhibiting unusual symptoms, such as skip-
ping a label, you may need to recalibrate the printer. See “Calibration” on
page 15.
Resetting to Factory Default Values.
Resetting the printer to the
factory defaults might solve some problems. For instructions, refer to
Table 1, “Feed Key Troubleshooting Modes,” on page 14.
Communications Diagnostics.
If you suspect problems in transfer-
ring data between the computer and printer, you may want to put the printer
in the Communications Diagnostics mode. In this mode, the printer prints
the ASCII characters and their corresponding hexadecimal values for any
data received from the host computer. For instructions, refer to Table 1,
“Feed Key Troubleshooting Modes,” on page 14. A typical printout is shown
in Figure 6.
Figure 5: Configuration Label (Sample)
55530lr4 Page 20 Wednesday, March 26, 1997 11:18 AM