Yamaha YST-M8 - Manual (Page 6)

6
Cautions
Please read the following operating precautions before use:
• Use the AC adaptor designed specifically for the YST-M8 only. Yamaha
cannot be held responsible for damage caused by using other power supply
adaptors.
• When disconnecting the AC adaptor from an AC receptacle, hold and pull the
adaptor, not the power cord.
• If the YST-M8 are not going to be used for a while, disconnect the AC adaptor
from the AC receptacle.
• Always disconnect the AC adaptor from the AC receptacle before making any
connections.
• YST-M8 do not contain any user serviceable parts. Refer all servicing to your
Yamaha dealer.
• Do not expose the YST-M8 to temperature extremes, direct sunlight, excessive
dust, humidity, or vibration.
• Place the YST-M8 on a level, stable surface. Do not drop the YST-M8, apply
excessive force to their controls, or put heavy items on top of them.
• If the YST-M8 should require cleaning, use a soft cloth. If necessary, use a
damp cloth.
• To protect the YST-M8 speakers, avoid microphone feedback, continuous and
excessive output from electronic musical instruments amplifiers signal
distortion.
• If the YST-M8 are located close to fluorescent or neon type lights, a slight
hum may be heard. In this case, relocate the YST-M8 away from the light.
• Although the YST-M8 speakers are magnetically shielded, keep floppy disks
and tapes away from them.
• The YST-M8 may cause picture distortion when placed close to a television or
computer monitor. In this case, move them away a little.
Thank you for purchasing Yamaha’s YST-M8 Powered Multimedia Speakers. Yamaha’s Active Servo Technology offers
exceptional high performance.
This unit is not disconnected from the AC power source as long as
it is connected to the wall outlet, even if this unit itself is turned off.
This state is called the standby mode.
In this state, this unit is designed to consume a very small quantity
of power.
Connections
Refer to page 4 for system connections.
Rear Panel (right cabinet) (Refer to page 5)
1
INPUT 1 and 2: These are 3.5 mm jack connections for inputting signals to
the YST-M8. Using these two inputs will mix two input signals.
For example, you may connect your CD-ROM player and personal computer
to these input terminals.
2
TO LEFT SPEAKER: This should be connected to the TO RIGHT
SPEAKER connection on the left-channel cabinet using the supplied RCA
plug cable.
3 OUTPUT (ADJ. VOL.): This 3.5 mm stereo jack outputs the input signal
after the VOLUME control.
4 DC 12V: Connect the supplied AC adaptor to this connection.
Rear Panel (left cabinet)
5 TO RIGHT SPEAKER: This should be connected to the TO LEFT
SPEAKER connection on the right cabinet using the supplied RCA plug cable.