Yamaha YST-M8 - Manual (Page 7)

7
Specifications
Type Active Servo Technology
Output power 5 W + 5 W (1 kHz, 4
Ω
)
Input sensitivity 200 mV (1 kHz, 4
Ω
at 5 W)
Input Impedance 25 k
Ω
Frequency response 80 Hz to 20 kHz
Speaker unit 6.5 cm (2.5") full-range cone, magnetic shielding
Output Impedance 600
Ω
Output level 0.9 V (at 200 mV Rated Input)
Power supply DC 12 V
U.S.A. and Canada models AC 120 V, 60 Hz
Europe and U.K. models AC 230 V, 50 Hz
Australia model AC 240 V, 50 Hz
Dimensions (W
×
H
×
D) 86 (3 3 /
8
")
Ч
216 (8 1 /
2
")
Ч
130 (5 1 /
8
") mm
Weight 0.7 kg (1 lb 9 oz.)/Right channel unit
0.6 kg (1 lb 5 oz.)/Left channel unit
Finish YST-M8 W: Computer white
YST-M8 B: Black
Accessories AC adaptor
×
1
3.5 mm stereo mini plug cable
×
1
RCA plug cable
×
1
8 non skid pads
×
1
* Specifications subject to change without notice.
Non skid Pads
The pads supplied with the YST-M8 should be stuck onto
the bottom of each speaker cabinet as shown. As well as
preventing the YST-M8 from slipping around, these pads
also isolate the cabinet from the mounting surface.
Controls
Front Panel (right cabinet) (Refer to page 5)
6
(power) switch and indicator: Press the (power) switch to turn on the
YST-M8; the indicator will light up. Press it again to turn off. Before
turning on and off, turn down the VOLUME control.
7
VOLUME control: Use this control to set the volume level. Turn it clockwise
to increase the volume, and counterclockwise to reduce it.
8 TONE control: This control allows frequency boost and cut up to
±
7 dB at
10 kHz. This tends to emphasize vocals, providing a warmer intimate sound.
Turn it clockwise to boost, and counterclockwise to cut.
9 (headphones) jack: Use this jack to connect stereo headphones for
monitoring. No sound is output from the speakers or the OUTPUT
(ADJ.VOL.) jack when headphones are connected.
English