ZyXEL Communications P-2304R-P1 Series - Manual (Page 84)

Chapter 6 WAN
P-2304R-P1 Series User’s Guide
84
Each field is described in the following table.
Table 34 Network > WAN > Traffic Redirect
LABEL DESCRIPTION
Active Select this to set up a backup gateway in case the default gateway is not
available. (For example, this might happen if the Internet connection goes down.)
Clear this if you do not have a backup gateway.
Backup Gateway
IP Address
Enter the IP address of the backup gateway. The ZyXEL Device automatically
uses this gateway if the default gateway is not available anymore.
Check WAN IP
Address
Enter the IP address of a reliable nearby computer the ZyXEL Device uses to test
whether or not the default gateway is available anymore. For example, use one of
your ISP’s DNS server addresses.
If you enter 0.0.0.0, the test fails each time.
Fail Tolerance Enter the number of consecutive times the ZyXEL Device may attempt and fail to
find the reliable nearby computer at Check WAN IP Address before it starts using
the backup gateway. 2 - 5 are typical choices.
Period (sec) Enter the number of seconds between attempts to find the reliable nearby
computer at Check WAN IP Address. 5 - 60 are typical choices.
Timeout (sec) Enter the number of seconds the ZyXEL Device waits for a response from the
reliable nearby computer at Check WAN IP Address before the attempt is a
failure. 3 - 50 are typical choices, but this number should be less than the Period.
Apply Click this to save your changes and to apply them to the ZyXEL Device.
Reset Click this to set every field in this screen to its last-saved value.