Zebra Technologies RP - Manual (Page 9)

9 UMAN-Charge
continued on next page
UCN72-4 Quad Charger
Description
The UCN72-4 Quad Charger is designed to charge up to
four NiMH Encore and/or Cameo series batteries simulta-
neously. Battery packs may be charged externally or while
plugged into the printer. The unit has switch selectable 110/
220 V.A.C. input voltage and is supplied with a line cord
compatible with its country of use.
Charging Batteries
Set the voltage selection switch on the unit’s rear panel to
agree with the supplied A.C. voltage. Refer to diagram below
and to table.
To charge batteries: Plug the
line cord into the charger and
then into the A.C. supply recep-
tacle. The power
indicator on the
front panel will
light.
Plug a charge
cable into the
charger jack on
Voltage set to
115 V.A.C.
Voltage set to
220 V.A.C.
Charge Indicator Power Indicator
Charge
Cable
S
ETTING THE
V
OLTAGE
S
WITCH
UCN72-4