Yamaha DSP-A990 - Manual (Page 31)

29
English
To record the input source
1. Press the REC OUT switch (so that “REC OUT...” appears on the
display and the monitor screen).
Front panel
2. Within 5 seconds, select the “SOURCE” position with the input
selector switch (so that “REC OUT SOURCE” appears on the
display panel and the monitor screen).
Front panel
3. Press the REC OUT switch (so that “REC OUT SOURCE”
disappears from the display).
* The same result will be obtained after 5 seconds without any
operation.
4. Select an input source to be played (and to be recorded).
(See page 28 for the method of input source selection.)
Front panel Remote Control
5. Play the source.
6. Set the tape deck or VCR used for recording to the recording
mode.
*
Adjust the recording level on the tape deck or VCR.
NOTE: To record picture from a video source and sound from
another audio source, in step 4, first select a video source with an
input selector switch on the front panel, and then select an audio
source with the input selector keys on the remote control unit.
2-2. RECORDING A SOURCE TO AUDIO/VIDEO TAPE
(OR DUBBING FROM A TAPE TO ANOTHER)
PHONO
TV/DBS
INPUT SELECTOR VCR I CD LD
CD
INPUT SELECTOR VCR I CD LD
REC OUT SOURCE
or