Zanussi ZWH6121 P - Manual (Page 6)

6
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
Important!
Very carefully
remove the front
polystyrene block
(B) by gently pulling
the polyethylene
bag (1) downwards
then (2) out,
ensuring not to tear
the bag (If fitted).
Using a spanner
unscrew and
remove the two rear
bottom screws.
Lay the machine
on its back
ensuring that the
hoses are not
crushed. Place
one of the
polystyrene angle
packings under
the machine.
Some models are provided with a bottom
cover that will be found inside the washing
machine drum. After ensuring the polyethylene
bags have been removed, follow below
instruction:
Remove the
polystyrene base,
set the machine
upright and unscrew
the remaining rear
screw. Slide out the
relevant pin.
Slide out the two
plastic pins.
Remove the
polystyrene block
(A) protecting the
motor (If fitted).
Locate the
bottom cover as
shown in
position (C). (1).
Then push the
top end to lock to
the bottom of
washing machine. (2).
Cover all the open
holes with the plugs
which you can find in
the bag containing
the instruction
booklet.
A
C
1
2
2
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or cupboard units.
1
2
B