ZyXEL Communications 56K Plus Series - Manual (Page 36)

Omni 56K Plus Series User’s Guide
4-8 Command Sets
Table 4-4 Extended AT* Command Sets
COMMAND OPTIONS FUNCTION & DESCRIPTION REF.
*Q3 Disconnect if signal quality is poor.
*T Recall the last CND (Caller ID) information. S40.2
*V Views password table.
4.1.4 Extended AT# Command Sets
Table 4-5 Extended AT# Command Sets
COMMAND OPTIONS FUNCTION & DESCRIPTION REF.
#En Modem status in escape state
#E0 Disable the report of modem status in escape state
#E1 Enable the report of modem status in escape state
4.2 Fax command sets
4.2.1 Service Class 1 Commands
Table 4-6 Service Class 1 Commands
COMMAND DESCRIPTION VALUE
+FCLASS=n Service Class Identification and Control n=0:Sets to modem mode
n=1:Sets to Class 1 mode
n=2.0:Sets to Class 2.0 mode
n=8:Sets to Voice mode
+FTS=n Stop Transmission and pauses n=0-255 in 10 ms units.
+FRS=n Wait for Silence n=0-255 in 10 ms units.
+FTM=<MOD> Transmit Data with <MOD> Carrier See table 16
+FRM=<MOD> Receive Data with <MOD> Carrier See table 16
+FTH=n Transmit HDLC Data with <MOD>=3 Carrier n=3
+FRH=n Receive HDLC Data with <MOD>=3 Carrier n=3
The value of <MOD> parameters lists as below:
Table 4-7 The Value of <MOD> Parameters
VALUE MODULATION SPEED
3 V.21 ch 2 300
24 V.27ter 2400
48 V.27ter 4800
72 V.29 7200
73 V.17 7200