Yamaha NX-SW70 - Manual (Page 6)

4
USING THE SPEAKER MOUNTING BRACKETS
Using Commercially Available Speaker Stands (distance between screw
holes: 60 mm)
1
Attach the type B brackets to the bottom of the
speakers using the provided screws.
Align so that the protrusion on the bracket goes into the
groove on the bottom of the speaker.
2
Mount the speaker on the speaker stand using
the bracket holes (spaced at 60 mm).
Be sure to ready the small screws (diameter: 4 mm,
length: 8 mm), spring washers and washers.
CAUTION
Be sure to read these important precautions.
• Each speaker weighs approximately 0.7 kg. Select a
firm wall or pillar to attach screws to. Do not attach
screws to material such as mortar or veneer as screws
may come loose easily, causing the speaker to fall.
• Do not mount speakers using nails or tape as
vibrations during operation may cause nails to come
loose or tape to peel off, causing the speaker to fall.
• Take care that the speaker cord is not pinched between
the speaker and the bracket. Be sure that the speaker
cord passes through the groove on the rear panel of the
speaker.
• Secure the speaker cords so that they will not catch on
hands or feet, causing speakers to drop.
• Be absolutely sure to check for safety after speakers
are mounted. YAMAHA bears no responsibility for
damage caused due to improper installation or
installation in an improper location.
60 mm
Provided screw
Type B bracket
0102NX-SW70_01_EN 3/29/0, 10:21 AM 4