Zanussi ZXS 646 IT - Manual (Page 11)

11
These hobs can be inserted in a built-in kitchen unit
whose depth is between 550 and 600 mm. The hobs
dimensions are shown in the relevant diagram.
The edge of the cut out must have a minimum distance
from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near
the hob, the cut out edges must have a minimum
distance of 100 mm.
Hanging furniture units or hoods must be placed at 650
mm. minimum from the hob.
A = Auxiliary burner
SR = Semirapid burner
PE = Electric hotplate
Fitting the hob to the worktop
The hobs can be installed in a kitchen unit with an
opening for insertion whose dimensions are shown in fig.
9. To install the hob, proceed as follows:
1) Remove the pan supports, the burners caps and
crowns and turn the hob upside down, taking care the
ignition candles are not damaged in this operation.
2) Place the sealing gasket (supplied with the hob) on
the edges of the cut out, taking care that the sealings
meet without overlapping;
3) Fix the hob with the relevant fixing clamps, supplied
with the accessories bag (fig. 10). The traction of the
screws is able to trace the sealing, any excess of
which can be easily removed.
The edge of the hob forms a double labyrinth seal which
provides a total guarantee against infiltration of liquids.
WARNING: When securing the fixing clamp near
the terminal block, always ensure the connection
cable does not come in contact with the edge of
the clamp (see fig. 11).
Fig.9
Fig.10
a) Sealing gasket
Dimensions are given in millimeters
Building In
FO 2098
FO 0199
a
500
580
PE
SR PE
A
A
B B
A
YES NO
Fig.11
A) Fixing clamp
B) Connection cable