Tuning, Connecting the antennas, Connecting the indoor fm antenna – Yamaha RX-V800RDS User Manual
Page 32: Connecting the am loop antenna
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
Connect each antenna correctly to the designated terminals.
AM loop antenna
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A
good earth ground is a metal stake
driven into moist earth.
■ Connecting the indoor FM
Connect the included indoor FM antenna to the 75
UNBAL. FM ANT terminal.
• Do not connect an outdoor FM antenna and the indoor FM
antenna at the same time.
■ Connecting the AM loop antenna
Press and hold the tab to unlock the terminal
Insert the AM loop antenna lead wires into
the AM ANT and GND terminals.
Release the tab to lock the lead wires.
Lightly pull the lead wires to confirm a good
Attach the loop antenna to the antenna
Orient the AM loop antenna so that the best
reception is obtained.
• The AM loop antenna can be removed from the stand and
attached to a wall, etc.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
Connecting a coaxial cable to the included
75-ohm/300-ohm antenna adapter (U.K. model
Insert the wire
into the slot.
Open the cover of the
Cut the external sleeve of
the 75-ohm coaxial cable
and prepare it for
Cut the lead wire and
Insert the cable wire into the
slot, and clamp it with
Snap the cover into