Zanussi ZOB 383 - Manual (Page 13)

Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not set Control the settings
The oven does not heat up The fuse in the fuse box is released Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
Steam and condensation settle on the
food and in the oven cavity
You left the dish in the oven for too
long
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
The display shows “12.00” A power cut Reset the clock
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Installation
Warning! Refer to "Safety information" chapter.
594
2
20
570
590
540
560
50
580
550 min
560÷
570
550 min
593
560-570
80÷100
A
B
Electrical installation
Important! The manufacturer is not responsible if you do
not obey the safety precautions from chapter "Safety".
This appliance is supplied without a main plug and a main
cable.
Applicable types of cables for Europe: H07 RN-F, H05
RN-F, H05 RRF, H05 VV-F, H05 V2V2-F (T90), H05 BB-
F
13