ZyXEL Communications PLA-400 - Manual (Page 41)

Chapter 4 Powerline Network Setup Tutorial
PLA-4xx Series User’s Guide
41
Figure 32 Adapters on a New Powerline Network
• If you want to access any of your new powerline networks using the PLA-4xx Series
Configuration Utility, change the Network Password (NMK) on your local adapter to
the network password for the network you want to access. The adapters on that network
will then display in the adapter table, allowing you to select and configure each one.
4.1 Troubleshooting
The LINK ( ) LED (light) should light up on your adapter when it successfully connects to
other adapters on your network. If it does not, try the following measures.
• Make sure the adapter is plugged in to a power socket and the power socket is turned on.
• Check you have entered the correct network password (NMK) for your network.
• Check your powerline adapter is connected to the same electrical circuit as other
powerline adapters on your network.