Zoom A2.1U - Manual (Page 30)

ZOOM A2.1u 30
Effect Types and Parameters
MOD/EFX
MOD/EFX (Modulation/Effects) module
Comprises modulation and delay effects such as chorus, wah, delay, and echo.
CH CHORUS
This effect mixes a variable pitch-shifted component to the original signal, resulting in full-bodied resonating sound.
DEPTH 0 – 98, 1.0 RATE 1 – 50 MIX 0 – 98, 1.0
Adjusts the modulation depth.
Adjusts the level of the effect
sound mixed to the original
sound.
Adjusts the modulation rate.
CH
This is a warm sounding long delay of up to 5000 ms duration.
Pd PINGPONG DELAY
This is a ping-pong type delay wher e the delay sound alter nates between left and right.
These three ef fect types have the same parameters.
TIME 1 – 99, 1.0 –
5.0 FEEDBACK 0 – 98, 1.0 MIX 0 – 98, 1.0
Adjusts the delay time. In the
range from 10 – 990 ms, the
adjustment is made in 10-ms
steps (1 – 99). For 1 second and
above, the adjustment is made in
100-ms steps (1.0 – 5.0)."
Adjusts the feedback amount.
Adjusts the level of the effect
sound mixed to the original
sound.
HOLD
PD
HOLD
TAP
TAP
HOLD
Effect parameters 1 – 3
Effect type
These are the parameters that can be adjusted with
parameter knobs 1 - 3 when the effect type is selected. The
setting range for each parameter is shown.Three-digit setting
values are shown with a dot between the two numerals.
Example: 0 - 98, 1.0 = 0 - 98, 100
Expression pedal
A pedal icon ( ) in the listing indicates a parameter that can be controlled with the built-in
expression pedal.
To control a parameter with the expression pedal, specify the respective module (or parameter)
as control target for the pedal (→ p. 24), and then select the respective effect type of the module.
Tap
A tap icon ( ) in the listing indicates a parameter that can be set by repeatedly hitting
(tapping) the foot switch (FS01). The tap function must have been assigned to the foot switch
beforehand (→ p. 25), and a module that includes this parameter must be on.
In edit mode, tapping the foot switch will cause the respective parameter to be set according to
the tapping interval (modulation cycle, delay time, etc.).
In play mode and manual mode, tapping the foot switch will cause the TIME parameter of the
delay effect type in the DELAY/REVERB module to be temporarily changed. (In play mode and
manual mode, only the delay effect in the DELAY/REVERB module can be controlled by tap
input.)
Hold
A hold icon ( ) in the listing indicates an effect type for which hold can be turned on
and off with the foot switch (FS01).
Set the foot switch function to "dH" (delay hold) (→ p. 25) for the respective patch. When this
patch is then selected in play mode or manual mode, the hold function can be switched on and
off by pressing the foot switch.
Module selector
The Module selector symbol
shows the position of the
selector knob at which this
module/parameter is called up.
Effect module
How to read the parameter table
eA21u.fm 30 ページ ２００５年１１月４日 金曜日 午後５時２３分