Zenith Data Systems MT2000 - Manual (Page 167)

6-24
Problem Solving
Table 6-3. POST Tests (continued)
Code Beeps POST Routine Description
The following are for boot block in FLASH ROM
E2 4-3-1-3 Initialize the chipset
E3 4-3-1-4 Initialize refresh counter
E4 4-3-2-1 Check for Forced Flash
E5 4-3-2-2 Check HW status of ROM
E6 4-3-2-3 BIOS ROM is OK
E7 4-3-2-4 Do a complete RAM test
E8 4-3-3-1 Do OEM initialization
E9 4-3-3-2 Initialize interrupt controller
EA 4-3-3-3 Read in the bootstrap code
EB 4-3-3-4 Initialize all vectors
EC 4-3-4-1 Boot the Flash program
ED 4-3-4-2 Initialize the boot device
EE 4-3-4-3 Boot code was read OK
System and Disk Status LED User’s Information
This section lists and describes the various system and
disk status LED indicators and provides a user
response for the various status conditions.
Once your server is up and running, you can monitor
server operation through the system status LED panel
indicators and the SCSI device status LED panel
indicators. See Table 6-4 and Table 6-5 for a list and
description of the LED indicators and Table 6-6 for a
list of the system status abnormal conditions.
If any problems persist, contact your service
representative for assistance.